Installation Electrical Test

Name *

First

Last

Date of Birth

Home Address

Home Phone

Cell Phone

Emergency Contact

Emergency Contact Phone number

1. Do you have a Valid Driver license?

Yes
No

2. If yes please enter your Driver license number?

3. Do you have reliable transportation?

Yes
No

4. Are you willing to travel 80% of the time throughout the U.S and Canada?

Yes
No

5. Do you like to travel?

Yes
No

6. What are your hobbies?

7. Do you have any misdemeanors or felonies?

Yes
No

1. Have you ever installed a radio in a Vehicle?

Yes
No

2. Have you ever worked on buses trucks or trains?

Yes
No

3. Please describe what you have done on Vehicles?

4. Have you ever done any type of installation?

Yes
No

5. Please specify

6. Have you ever done low Voltage electrical?

Yes
No

7. Have you ever installed Cameras?

Yes
No

8. Have you ever installed wifi or other communications systems?

Yes
No

9. Please specify?

10. Have you ever managed a project?

Yes
No

11. Do you know how to solder wires?

Yes
No

12. Can you read an electrical diagram?

Yes
No

1. Please select the best way to bundle wires?

1
2
3

2. Please explain how you would tap into an electrical circuit to connect inputs?

3. Please explain your method of finding inputs such as Brake turn signals or door?

4. On a 12 volt relay what is the purpose of terminal 86

5. On a 12 volt relay what is the difference between terminal 87a and 87?

6. What is a short in an electrical circuit?

7. How can you prevent a short from damaging the vehicle?

8. What is the purpose of a diode?

9. What is a resister?

10. What would you use to test continuity?

11. When checking voltage on a circuit with a 24 volt battery supply if you find a wire input to a module with only 4 volts what should you do?

A. Install a 4 volt relay and relay a power from a 24 volt source to the module
B. Do nothing it is ok
C. Find another input source
D. I don’t know I would ask my supervisor

12. When checking for inputs if you find a brake signal that is grounded when the brake is pressed what should you do?

A. Check it for a short to ground
B. Check it for an open circuit
C. Connect the ground trigger to terminal 85 of a relay and 87 as a signal input to the system weare installing and install a Diode to protect the oem side of the circuit.
D. Connect the ground trigger to terminal 85 of a relay and 87 as a signal input to the system weare installing and install a Resister to protect the oem side of the circuit.
E. I don’t know I would ask my supervisor

13. When running a cable or wire with no access panels what method would you use to install the wire?

A. Cut a hole in paneling run the wire and reseal using adhesive with rivets after Running wire?
B. Cut a hole in paneling run the wire and reseal using only adhesive.
C. Remove light fixers and run the wire using Fish tape.
D. Use fish tape to run the wire but never remove light fixers.
E. I don’t know I would ask my supervisor.

14. When running Camera wires how would you know which port to connect the wires

A. Label the wires before installing.
B. Turn on system and look at the cameras
C. Label the wires after they are ran to the correct location
D. Do a continuity test on each wire
E. I don’t know I would ask my supervisor

15. What is the difference between and IP camera and an analog?

E-mail:

Phone:

(562)395-2713

Copyright © 2021 | 4 TRANSIT